When decorating hydropower, even if you are present, how do you supervise the work without knowing it? Most of the owners’ friends will ask for beauty, so when you see some of the wires of the hydropower master’s shop are messy, I think this is messy wiring. However, there is a situation in which everyone has to know that when the home improvement electrician is decorated like this, the wiring is quickly stopped. Okay, let’s learn more about it with Xiaobian~
First, home improvement electrician - water and electricity wiring pay attention to horizontal and vertical
The wiring in the figure below is intended to go from point A to point B. It is obvious that a straight line can be fixed, but it has turned nearly five bends. What does this mean? The explanation is more than that, and this kind of right-angled corner is a dead line. If there is a problem in the future, there is no way to repair it. This is not what we say "horizontal and vertical". Regarding the right angle bend that I said, here is a science popularization: According to the national regulations, a straight line cannot exceed two consecutive right angle bends. The correct way is to take the shortest distance as shown below.
Second, home improvement electrician - water and electricity wiring two places to pay attention to
1. Load-bearing wall: For the load-bearing wall, the slotted wiring on the wall must be straight and cannot be opened. The transverse groove will affect the bearing capacity of the bearing wall.
2. Lightweight wall: For light-weight walls, horizontal grooves can be opened, but not more than 50cm, and the inner insulation wall should not exceed 100cm.
Third, home improvement electrician - water and electricity wiring must pay attention to the principle of the shortest line between the two points
Water and electricity wiring is not just a pursuit of beauty, but more consideration should be given to whether it is practical. It is not important to start with a good look. It will not be sealed after the installation is completed. Even if it is ugly, it will not be seen. In view of the fact, the wire is not as good as the cloth, and you should not blindly pursue the beauty. Although this is a tortuous song, but it is more stable in it, even if you want to twitch, it will not be easy to extract. Moreover, in the wiring, we must pay attention to the principle of the shortest line between the two points, in order to save money and materials for the owners, and will not easily fail.
Fourth, home improvement electrician - threading principle
The last place that is easy to hang people is the most common decoration. It is: only one wire is worn inside a PVC pipe. According to the regulations, a PVC pipe should wear at least three wires. If the worker wears only one, then your money will continue to rise.
The above is a detailed answer to the home improvement electrician, I don't know if you are satisfied with the introduction of the decoration home network Xiaobian~ If you want to know more about the home improvement electric related aspects, please continue to pay attention to our decoration encyclopedia Forum!
Planar beam loadcells, also known as planar force sensors, are used in low profile solutions where space is limited. These loadcells can be used as single or multiple loadcell structured platform scales.
Applications with planar beam loadcells
Most of the applications using planar beams are suited with 3 or 4 pieces for each application. which are used for point-of- sale scales/weighing systems in the 10 to 400 pound range. The low profile weighing equipment can be found in many different applications like medical applications (hospital bed and chairs, baby scales, incubators), checkout counters, agricultural devices, retail scales, bench scales and many other weighing devices.
Planar Beam Load Cells,Planar Beam Load Cell,Planar Force Sensors,Multiple Load Cell
Zhejiang Nanhua Electronic Technology Co., Ltd , https://www.nhloadcell.com