How to carry out the scraping of the sliding bearing

Source: Bearing network time: 2017-11-23

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

Before scraping; should carefully check whether the journal can be lubricated; whether there are any defects such as rust and bump; if it should be solved first, then; check the contact condition of the journal and shaft; view the method; apply on the shaft diameter a thin layer of developing agent (such as red powder, red Qiang oil, etc.); then the journal is placed in the bearing; the hand is turned into two or three turns in the forward and reverse directions; the shaft is taken out; the dispersion of the colored points on the bearing is observed. The situation; if the color point spreads abnormally, the bottom can't turn;
When scraping; should be based on the situation; adopt the criteria of light weight first, light weight, light weight, and large size. Start a few times; the hand can be heavier; scrape some metal; to reach a better touch faster When the touch area reaches 50%; it should be lightly scraped. Every time it is scraped; wipe the tile surface; then apply the developer to the journal to check it; then scrape according to the touch condition; Stop. Scraping and viewing can use the developing agent; but the fine bearing with high demand for the touch point; the developing agent can not be used in the final period of scraping. Because; after the application of the developing agent; the coloring point on the bearing is too large; Touch condition. At this moment; the journal can be wiped clean; directly placed in the bearing to check; then the shaft is taken out; the bright spot on the bearing can be seen; that is, the touch point. Then the spot is scraped; until the skill needs are stopped .
Scrape; not only make the touch point meet the skill needs; but also make the side gap and touch angle reach the skill demand. Usually touch the touch point first; also look at the touch angle together; finally scrape the side gap. However; touch some Some touches should not have significant boundaries; when you wipe the bearing's appearance with your fingers; you should not notice any traces.
The oil tanker depends on experience; but mainly to grasp the criteria:
1. Lubricating oil should be input into the bearing from the minimum pressure of the oil film.
2. The oil tank is opened in the non-load bearing area; otherwise, the bearing capacity of the oil film will be lowered.
3, the axial direction of the oil tank can not be registered; to avoid oil loss from the end of the oil tank,
4. The bearing oil groove of the horizontal device is opened for half a week; do not extend to the bearing area; the oil groove of the whole week should be opened close to the end of the bearing.
Others; the oil hole is opened at the top of the bearing bush; the oil groove can be surrounded by the oil inlet hole; the oil groove with the width and the hole diameter is flat; the shape can adopt the "one" shape, the "x" shape, the "king" shape and the like.

Recommend to friends comments close window

Bearing related knowledge

What are the new specifications for bearing grinding and the specifications for the elimination of sliding bearings?
Analysis of the method of hot-loaded skf bearing analysis of single-stage single-suction centrifugal pump bearing smoothing method

This article links to http://
Please indicate China Bearing Network http://

Previous:The eight major categories of bearing occupations are as follows: Characteristics and use of main bearing oil

Galvanized Wire

Galvanized wire is divided into hot dipped galvanized wire and cold galvanized wire (Electro Galvanized Wire). Galvanized wire has good toughness and flexibility, the maximum amount of zinc can reach 350 g /sqm. With zinc coating thickness, corrosion resistance and other characteristics.

Galvanized Wire,Steel Iron Wire,Galvanised Mesh,Electro Galvanized Welded

Shenzhou City Hongda Hardware Products Co.,Ltd , https://www.galvanziedwire.com