Nowadays, every household needs to install a good toilet. How should this toilet cover be installed ? Now we have a small series of our decoration home to introduce you, our toilet cover is installed with several correct ones. A quick and easy way, as well as some precautions when installing the toilet lid, our friends can learn from the articles in the small series.
First, the toilet cover installation method
1. Remove the original toilet cover: The ordinary toilet cover usually bolts the hinge directly to the mounting hole. It can be done directly with a wrench and a screwdriver. A higher-grade toilet seat with a descending damper may require the damper at the hinge position to be removed first, usually with a screwdriver from the inside of the hinge.
2. Disassemble the box of the smart toilet cover, take out the instructions and install the accessories. Note that there is usually a positioning drawing card, which is placed at the position of the mounting hole at the back of the toilet, and the card at the position of the nozzle is folded into a right angle, which is placed at the rear edge of the toilet, so that the card for mounting is aligned with the hollow of the drawing card. Position, use the bolts in the accessory kit to align and fix them separately.
3, water cut. Rotate the inlet flange valve of the toilet 90 degrees, then vent the water in the toilet tank to see if it is no longer in the water. After confirming that it has been closed, use a wrench to loosen the inlet pipe connection of the toilet.
4, the installation is complete, power-on test. Insert the safety plug of the smart toilet into the power supply, press the disconnect button to see if it can be powered off, and confirm that the ground connection is safe.
Second, the toilet cover installation precautions
1. Before installing the toilet, it is necessary to carry out calculations and various accurate measurements to ensure that the toilet is installed correctly. First, the toilet installer should check the drain pipe of the toilet to see if there is any blockage in the pipe. Also check the level of the ground. If it is not smooth, you need to level the ground first. It is also necessary to shorten the size of the sewer, but at least two centimeters higher than the wall.
2. During the installation process, the bottom of the toilet needs to be glued with glass glue during the fixing process. However, it is necessary to control the gap between the toilet and the wall, and the toilet product needs to be squared. After installation, you also need to see if the flushing of the toilet is smooth and the switch is normal.
3. After installing the toilet, you need to check the water pipe and flush it for a few minutes to allow the pipe to be flushed. In order to ensure the cleaning of the water pipe, install the toilet fittings, and after installation, connect the water pipes. Then check the tightness, whether the toilet is used properly, and whether the drain pipe is smooth.
The above is the correct and quick way to install our toilet cover. You can refer to it. When we install the toilet cover, there are also many precautions. Xiaobian reminds everyone to pay more attention to it. Then there is a lot of decoration information in our decoration home network. Friends continue to pay more attention, thank you for reading this time!
More related wonderful reading:
Intelligent toilet cover installation feature intelligent toilet cover installation method
How to install the smart toilet cover? Smart toilet cover installation steps
How to install a smart toilet lid? Intelligent toilet cover installation process
How to install the toilet cover? What is the cost of installing the toilet cover?
Introduction to the installation method of the toilet cover: save money and protect yourself
Pressure Vessels Steel Plate,Pressure Vessels Steel Sheet,Quenched Tempered Steel Plate,Quenched Tempered Steel Sheet
Shandong Yiyuantong International Trade Co., Ltd. , https://www.yyttrade.com