[Pump News Asia] mortar pump has the most excellent wear resistance, impact resistance (especially low temperature impact resistance), creep resistance (resistance to environmental stress cracking) and excellent corrosion resistance, is more excellent performance A pump. The following Xiaobian to introduce you to install and use mortar pump matters needing attention, I hope for everyone to help. Note the installation and use of mortar pump Notes on the installation and use of mortar pump: 1. Before starting the pump should be carefully checked during transport, storage, installation, whether the deformation or damage, the fastener is loose or off. 2. Check the cable for any damage, breakage and other phenomena, if damaged, need to be replaced in order to avoid leakage. 3. Check the power supply is safe and reliable, the rated voltage must be consistent with the nameplate. 4. With a megger to check the motor stator winding cold ground resistance value of not less than 50M. 5. Do not use the pump cable as a mounting and lifting rope, to avoid danger. 6. Pump rotation direction from the inlet as a counterclockwise rotation, if reversed, any two wires in the cable must be transferred to the wiring position, the pump can be forward. 7. The water pump should be vertically into the water, do not allow horizontal, can not be trapped in the sludge, pump movement, you must cut off the power. 8. After the pump is used for many times, it must be put in clean water and run for a few minutes to prevent deposits from leaving the pump and ensure the pump is clean. 9. Do not long-term electric pump, the pump should be removed from the water to reduce the motor stator winding damp opportunity to increase the service life of the pump. 10. Under normal working conditions, after one year's operation, the electric pump should be under the maintenance, replacing worn parts, checking the fastening status, supplementing or replacing the bearing grease and the oil in the oil chamber, Pump is working well. Further reading: Motor IFAT China's top ten brands Guangzhou Exhibition building water pump manufacturers ranking ptc Show article belongs to Internet industry (Xiamen) Co., Ltd. All are welcome to reprint, please indicate the source and author of: Asian pumps Network Editor : Gogoing (QQ / wechat:) starting: http://beng.liuti.cn/ (service hotline:)

Tension & Compression Load Cells

Tension and compression load cells can be used to measure both tensile and compressive loads. Manufactured from stainless steel or aluminium alloy, these tension and compression load cells offer a high level of corrosive resistance for use in harsh environments with environmental sealing up to IP68. Available in capacities from 1kg to over 100 tonnes, all tension and compression load cells are supplied with a full certificate of calibration. Custom designed tension and compression load cells are also available, along with a wide variety of associated instrumentation.

Benefits:

High accuracy
Hassle free installation
Long term, reliable operation
Customisable

Compression Sensor,Tension Sensor,Compression And Tension Sensor,Compression/Tension Sensor

Zhejiang Nanhua Electronic Technology Co., Ltd , https://www.nhloadcells.com