1. Speed ​​measurement range: 400-30000 revolutions
2. Vibration measurement range: 0-3000 μm peak-to-peak
4. One time removal imbalance rate >80%
5. Phase tracking accuracy: less than ±1° within 0-360°
6. Display mode: Four lines of large character LCD display two measuring points at the same time
PHY-balance measurement instrument operation precautions:
The user does not press the "Reset" key during the continuous measurement process, otherwise all the data of the key will be lost. If you have an influence factor at hand, you can re-enter it.
Be sure to carefully do a good job of photoelectric sign to observe the accuracy of the machine speed. This is an important guarantee for the instrument to perform dynamic balance testing.
There are many reasons that cause the machine to vibrate. Only when the amplitude of the same frequency occupies a large component of the total amplitude, the dynamic balance method can reduce the vibration. On the contrary, the desired effect cannot be obtained.
In the dynamic balance test method, it is necessary to add the know test to the known position of the measured surface, and pay attention to the amplitude and phase of the vibration and the change of the original amplitude and phase of the vibration. If the data change is not obvious, the effect of vibration reduction after calculation is not obvious. If the amplitude change is not obvious, the weight of the test should be increased. If the phase change is not obvious, the position of the test weight should be moved again.
Balancing a rotor for the first time must be performed with a trial weight method. After the impact coefficient is obtained by the trial weight method, the same type of rotor can be balanced by the available influence coefficient method, and the operation is relatively simple.
The PHY-balance meter can be powered by AC 220V, or it can be powered by an internal 12V battery. The general requirement is to use AC 220V to charge and 12V battery to supply power, so the internal noise is relatively small. Please note that when the battery voltage is lower than 10V, it is required to charge in time. Otherwise it will affect the battery life.
The sensor is equipped with a magnetic suction base that is very easy to grip. Please pay attention.
The Cordless 20V 4Ah Jigsaw is used for Cutting Wood, Plastic Tube, Aluminum Bar, with 6 speed, 4 Pendulum Settings, Bevel Cutting 47°. No burrs with good blade.
The Cordless Jigsaw is convenient to use at anywhere, wireless power supply, Battery is rechargeable.
The Cordless Jigsaw is the wood working power tools, Perfect for cutting curve, hole digging,can cut 3cm circle.
Portable Cordless Jigsaw With variable speed, 0-2400rpm, for different material cutting.
The Cordless Jigsaw cutting Capacity: Wood:80mm, steel:10mm
The Cordless Jig Saw with 4 Pendulum, 0 setting for metal, 1 setting for wood, 2-3 setting for soft wood.
Cordless Jigsaw,Cordless Jigsaw with Battery and Charger,Cheap Jigsaw Tool,Cordless Jigsaw with Battery
Ningbo Brace Power Tools Co., Ltd , https://www.cnbrace.com