Maintenance of PVC wallpaper:
Wallpaper blistering: wallpaper blistering is a common problem, mainly because the unevenness of the glue applied to the wallpaper causes the surface of the wallpaper to contract and the excess moisture in the base layer, resulting in some built-in bubbles. In fact, the solution is very simple. Just use a normal sewing needle to pierce the air bubbles on the surface of the wallpaper, release the gas, then use a needle to draw a proper amount of adhesive into the pinhole. Finally, re-flatten and dry the wallpaper. Just fine.
The wallpaper is moldy: the mildew of the wallpaper generally occurs in the rainy season and wet weather, mainly because the wall is too moist. The solution to the wallpaper that is not too serious for mildew is as follows: wipe it with a white towel and apply a proper amount of water, or wipe it with soapy water. The best way is to go to the wallpaper shop to buy a special mold remover.
Wallpaper curling: The edge of the wallpaper may be caused by the uncleanness of the base layer, the adhesiveness of the adhesive is too low, or the edge of the wallpaper with a corner is less than 2mm. Solution: Use the rubber powder attached to the wallpaper and wipe it on the curling edge. , smooth the lifting position, blow with a hair dryer for about 10 seconds, and then press the hand until it is firmly adhered, and blow it dry with a hair dryer.
Wipe the wallpaper: Wipe the dirty area with a damp cloth or a dry cloth; do not contaminate the wallpaper with some colored materials, otherwise it will be difficult to remove; wipe the wallpaper should start at some avoidable corners or behind the door to avoid bad The reaction caused the wallpaper to be damaged.
Seasonal maintenance:
1. Pure paper-based products: Pure paper-based products can be divided into two types: plain paper base and copper paper base. However, in general, the surface is not protected by PVC coating, so it is necessary to pay attention to the method when cleaning. Use only a sponge or a colorless clean wet towel to gently wipe, and do not control too much water. If there are obvious stains, it can only be cleaned. Do not use excessive force to wipe the surface of the wallpaper.
2. Non-woven fabrics: Non-woven products have their natural advantages and should be handled with great care. It is preferred to use a feather duster to remove dust, and then use a clean wet towel to maintain the cleaning by sticking.
3. Natural materials: Natural materials are mostly dyed by dyeing cylinders. Because the color retention is not high, the water will be cleaned and there will be obvious discoloration. It is recommended to use a dry towel or feather duster to clean.
Custom restaurant chandelier can not only show your taste of life, but also express your restaurant position and show how your difference is comparing to other competitors. It can be done by different kind of materials like crystal, glass, acrylic, resin, ceramics, ABS etc. For the structure parts, you also have options from Stainless steel, aluminum, brass, iron, cooper and so on. Modern restaurant chandelier is the most popular style, customer can do DIY design as their needs.
Some Glass Chandelier, Modern Chandelier, Brass Chandelier and Metal Chandelier can be also matched to restaurant!
Lavius lighting is the supplier and manufacturer of large restaurant chandelier, just contact us for free solutions.
Custom restaurant chandelier,Modern restaurant chandelier,Large restaurant chandelier,restaurant chandelier supplier and manufacturer
Guangdong Lavius Lighting Co., Ltd. , https://www.lovuslight.com