| Home>Bearing knowledge> Reasons for the overheating of motor bearings and disposal methods |
Reasons for the overheating of motor bearings and disposal methods
Source: China Bearing Network Time: 2014-01-17
| /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
2. The rolling bearing grease is too little, too much or has iron scraps and other impurities. The bearing grease capacity should not exceed 70% of the total volume; those with impurities should be replaced.
3. The shaft and the bearing cooperate too tightly or too loosely. When it is too tight, it should be ground from the head; when it is too loose, it should be set to the shaft.
4. The bearing and the end cap cooperate too tightly or too loosely. The bearing chamber is processed when it is too tight; when it is too loose, the steel sleeve is set in the end cover.
5. The two caps or bearing caps of the motor are not properly installed. Install the end cap or bearing cap into the flat; tighten the screws.
6. The belt is too tight or the coupling is not properly installed. Adjust the belt tension; proofread the coupling.
7, the sliding bearing lubricant is too little, there are impurities or oil ring stuck. Should be refueling, new oil; repair or replace the oil ring.
Recommend to friends comments close window
| Bearing related knowledge |
| INA bearing uses oil smooth bearing. Application notes Bearing type suitable for project analysis. Bearing professor teaches you the bearing speed limit target bearing failure classification common sense analysis |
This article links to http://
Please indicate the bearing network http://
Previous:How to distinguish the authenticity of imported mechanical parts Next: Bearing processing grinding fluid and super essential oil gather supply and gather filtration process
Car Elevator,Auto Elevator,Automobile Elevator,Car Lift Elevator
Homefriend&FUJI Elevator Co.,Ltd , https://www.jfujilift.com