Use and Maintenance Method of SMC Air Source Treatment Unit

In pneumatic technology, SMC air filters, pressure reducing valves, and oil misters are called pneumatic three-pieces. In order to obtain a variety of functions, these three types of air source processing components are often assembled in sequence, called a pneumatic triple unit. For gas purification and filtration, decompression and lubrication.
The installation sequence of the SMC air source processing element is air filter, pressure reducing valve, and oil mist filter in order of intake direction. The triple unit is an indispensable gas source device in most pneumatic systems. It is the final guarantee for the quality of compressed air installed near the gas equipment. In addition to ensuring the quality of the three major components, the design and installation of the triple unit must also consider saving space. Operation is easy to install, can be any combination of factors.
a. The working medium should use clean and dry compressed air, and fully blow the air in the piping to prevent impurities from being brought into the system and cause the cylinder and valve to malfunction. Lubrication should be done in the piping system. Lubrication is recommended. Oil is transparent No. 1 oil (ISOVG32);
b. After the normal operation of the system, check the working conditions of the air filter and the oil mist sprayer, discharge the water in time (except for automatic drainage) and refuel.
c. When the cylinder and valve are not used for a long time, pay attention to the minimum operating frequency of 1/30 days;
d. Always check the operation of various pneumatic components and check for loose connection fastening screws. Is the seal of the component damaged? Find problems in a timely manner;
e. During maintenance, be sure to shut down the gas source beforehand, and empty the compressed air in the piping system to perform maintenance work to prevent accidents;
f. When the component is repaired and reassembled, the components must be cleaned and no impurities etc. can be brought into the system.

Electric Retractable Gate

It can be equipped with a scrolling display that displays 300-500 words of display content. It can also be equipped with intelligent infrared probe anti-collision device, which can automatically return to work when people or foreign objects are 20-30CM, thus ensuring the safety of vehicles and pedestrians.It can automatically open and close when automatic clutch is cut off. Manually open and close when manual clutch is cut off. The control system has control panel, push button switch, and other requirements. Equipped with wireless remote control.The door body is made of high-quality stainless steel and aluminum alloy profiles, and is hinged by the parallelogram principle. The drive is driven by special motor, worm and worm gear deceleration, and has automatic clutch or manual clutch.

Factory Sliding Retractable Gate,Aluminum Alloy School Sliding Gate,Automatic Electric Single Double Gate,Store Retractable Gate

Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.hfhighspeeddoor.com